Fagor CNC 8070 - ISO Coordinate Rotation

OF 96
E
XAMPLES MANUAL
Conversational
programming
Exercise 3. Cam
Chapter 2
Page 36 of 96
CNC 8070
ISO COORDINATE ROTATION
Once the form has been inserted into the program, program an ISO command to rotate the
coordinate system in order to repeat the machining operation on the other side. The ISO block
will be:
N1: (First label)
#POCKET2D BEGIN (1-3C2D) Canned cycle.
--------------------
--------------------
--------------------
N2: (Second label)
G73 Q180 Coordinate rotation.
#RPT [N1,N2] Block repetition.
G0 Z100
M30