OF 96
E
XAMPLES
MANUAL
Conversational
programming
Exercise 4. 3D
pockets
Chapter 2
Page 40 of 96
CNC 8070
3D POCKET CANNED CYCLE.
GEOMETRY
P.3D Name of the 3D pocket Pocket3D-1
P.XY Name of the profile file. * Profile-2
P.Z1 Depth profile. ** Profile-3
P.Z2... Depth profiles.
Z Height coordinate of the surface. 0
Zs Safety Z coordinate 2
P Profile depth. -17
ROUGHING
∆ Roughing pass 0
I1 Maximum penetration step. 5
Fz Penetrating feedrate at each pass (mm/min.) 100
β Side penetrating angle 0
F Finishing feedrate in mm/min. 1590
SRPM 680
T Number of the tool to be used 2
D Tool offset 1
Counterclockwise turning direction
SEMIFINISHING
I2 Maximum penetration step 0.5
F Finishing feedrate in mm/min. 1590
S Spindle rpm for roughing 680
T Roughing tool number 2
D Offset for that tool 1
Counterclockwise turning direction
To Next Page
Loading...
