E
XAMPLES
MANUAL
Chapter 2
Page 41 of 96
Conversational
programming
Exercise 4. 3D
pockets
CNC 8070
* Pressing the [RECALL] in this box, the CNC shows the Profile Editor screen where the geometry
will have to be drawn. Once the profile is completed, the screen will return to the 3D pocket form
and the profile must be confirmed by pressing [ENTER]. The following section describes how
to use the profile editor.
** P.Z2, Z3, Z4. Depth profiles allowed, if there is only one or two, the rest will be left blank.
REMARKS
This machining data is for using a hard metal endmill without covering and two teeth.
FINISHING
e Roughing pass 0.5
d Maximum penetration step. 5
F Finishing feedrate in mm/min. 1590
S RPM 680
T Number of the tool to be used 2
D Tool offset 1
Counterclockwise turning direction
Zig Zag
To Next Page
Loading...
