Fagor CNC 8070 - Pocket Canned Cycle. Profile Editor

OF 96
E
XAMPLES MANUAL
Conversational
programming
Exercise 4. 3D
pockets
Chapter 2
Page 42 of 96
CNC 8070
3D POCKET CANNED CYCLE. PROFILE EDITOR
First make the rectangle defining the outside contour of the figure to be made. Use the "line"
command to set the first coordinate of the profile in the center of the figure.
BEGINNING
X=-58 Y=0 VALIDATE
STRAIGHT
X = -58 Y = -41 VALIDATE
X=58 Y=-41 VALIDATE
X=58 Y=41 VALIDATE
X=-58 Y=41 VALIDATE
X=-58 Y=0 VALIDATE
END
SAVE PROFILE
Once you programmed this profile, the external contour of the geometry would already be
defined. Then, use the P.Z1 box to do the pocket's depth profile.
BEGINNING
X=-58 Z=0 VALIDATE
STRAIGHT
X=-38 Z=-17 VALIDATE
END
SAVE PROFILE
Beginning of the profile in the
XY plane.
Beginning of the depth profile
in the XZ plane.