OF 96
E
XAMPLES
MANUAL
Conversational
programming
Exercise 5. 3D
pockets with islands
Chapter 2
Page 46 of 96
CNC 8070
3D POCKET CANNED CYCLE.
GEOMETRY
P.3D Name of the 3D pocket. Pocket3D.1
P.XY Name of the profile file. * p-1
P.Z1 Depth profile ** p-2
P.Z2 Depth profile *** p-3
Z Height coordinate of the surface 0
Zs Z depth coordinate 2
P Profile depth -15
ROUGHING
∆ Roughing pass 2
I1 Maximum penetration step 25
Fz Penetrating feedrate at each pass (mm/min.) 200
β Side penetrating angle 1
F Machining feedrate in mm/min. 510
SRPM 960
T Number of the tool to be used 9
D Tool offset 1
SEMIFINISHING
I2 Maximum penetration step 0
F Finishing feedrate 960
SRPM 510
T Finishing tool number 9
D Offset for that tool 1
To Next Page
Loading...
