E
XAMPLES
MANUAL
Chapter 2
Page 47 of 96
Conversational
programming
Exercise 5. 3D
pockets with islands
CNC 8070
* Pressing the [RECALL] in this box, the CNC shows the Profile Editor screen where the geometry
will have to be drawn. Once the profile is completed, the screen will return to the 3D pocket form
and the profile must be confirmed by pressing [ENTER]. The following section describes how
to use the profile editor
** P.Z2,Z3,Z4. Depth profiles allowed, if there is only one or two, the rest will be left blank.
FINISHING
ε Finishing pass 0.5
δ Finishing stock 0
F Finishing feedrate 960
SRPM 510
T Finishing tool number 9
D Offset for that tool 1
To Next Page
Loading...
