Fagor CNC 8070 - Operating modes

OF 96
E
XAMPLES MANUAL
Conversational
programming
Exercise 5. 3D
pockets with islands
Chapter 2
Page 48 of 96
CNC 8070
3D POCKET CANNED CYCLE. PROFILE EDITOR
Start by making the rectangle delimiting the external contour of the figure. Due to the importance
of the profile initial point, use the LINE command instead of the rectangle to do the figure.
BEGINNING
X=-30 Y=0 VALIDATE
STRAIGHT
X = -30 Y = -20 VALIDATE
X=30 Y=-20 VALIDATE
X=30 Y=20 VALIDATE
X=-30 Y=20 VALIDATE
X=-30 Y=0 VALIDATE
NEW PROFILE
CIRCLE
X=-9 Y=0 Xc=0 Yc=0 R=9 VALIDATE
END
SAVE PROFILE
Beginning of the depth profiles
in the XZ plane.
Beginning of the profiles in the
XY plane.