·108·
Operating manual
CNC 8070
5.
MANUAL (JOG) MODE
(REF: 1505)
Setting the feedrate and spindle speed.
5.5 Setting the feedrate and spindle speed.
Setting a new feedrate in the channel.
The feedrate set in jog mode is only applied in that work mode and for the active channel.
When setting a new feedrate in the MDI/MDA mode, it will become the new feedrate for the
jog and automatic modes.
Follow these steps to set a new feedrate.
1 Press [F] at the alphanumeric keyboard. The CNC will highlight the relevant data
indicating that it is selected.
2 Enter the new feedrate.
3 Press [START] to assume the entered value or [ESC] to cancel the operation.
Setting a new spindle speed.
The spindle speed set in the jog mode is applied to the spindle displayed at the time. If there
are several spindles in the channel, the rest of the spindles may be displayed by pressing
the [S] key. The spindle speed set in jog mode is maintained when switching to automatic
mode and vice versa.
Follow these steps to set a new spindle speed.
1 Press [S] at the alphanumeric keyboard until selecting the desired spindle. When
pressing this key for the first time, the CNC will highlight the relevant data indicating that
it is selected.
2 Enter the new spindle speed.
3 Press [START] to assume the entered value or [ESC] to cancel the operation.
To Next Page
Loading...
