·116·
Operating manual
CNC 8070
6.
MANUAL (JOG) MODE. TOOL CALIBRATION
(REF: 1505)
Manual calibration. Calibration without a probe
Entering wear values incrementally or absolutely.
In the tool table, it is possible to define whether the wear value being entered must be
incremental or absolute. See "Select the type of wear values to enter, incremental or
absolute." on page 257.
Using incremental wear, the value entered by the user will be added (or subtracted if it is
negative) to the absolute value of the wear. After pressing [ENTER] to accept the new value,
the wear field will show the resulting absolute value.
Initial wear Incremental wear Total wear
10.21.2
1-0.20.8
-1 0.2 -0.8
-1 -0.2 -1.2
To Next Page
Loading...
