CNC 8070
(REF: 1505)
7
·125·
MANUAL (JOG) MODE. PART
CENTERING (MILL MODEL)
Part centering is available in the jog mode. This option is only available at the mill model.
To quit the part centering mode and return to jog mode, press the [ESC] key.
Requirements prior to the calibration.
To execute this cycle, the probe must be properly calibrated. Before executing the cycle, the
probe must be placed near the part and in front of the probing point, as centered as possible
and in the Z coordinate where probing will take place.
Requirements prior to the calibration.
To center the part, follow these steps.
1 Select the probe and the offset. If not selected, the probe to be used must be defined
in the parameters of the cycle.
2 Enter the data of the cycle.
3 Press the [START] key to start the cycle. The CNC makes the necessary moves to center
the part.
4 When done with the cycle, the CNC updates the corresponding parameters.
Data returned by the cycle after the measurement.
Once the cycle has ended, the CNC returns the real values obtained in the measurement
in the following arithmetic parameters:
Optionally, in this cycle, it is possible to preset the coordinates to select a new part zero and,
in rectangular parts, rotate the coordinate axes to align the axes with the part.
This mode may be used to calculate the center of a rectangular or circular part of known
dimensions as well as, in rectangular parts, the inclination of the part with respect to the
abscissa axis. The type of part to be centered is selected with the parameters of the cycle.
Rectangular part. Circular part.
P296 Inclination angle between the part and the abscissa axis (rectangular part).
P297 Part surface coordinate.
P298 Part center coordinate along the abscissa axis.
P299 Part center coordinate along the ordinate axis.
To Next Page
Loading...
