·128·
Operating manual
CNC 8070
7.
MANUAL (JOG) MODE. PART CENTERING (MILL MODEL)
(REF: 1505)
Data programming.
·icon· Preset the part zero after ending the cycle.
This parameter indicates whether the part zero is to be preset or not, if so, the point taken
as reference. This point may be preset with any value using parameters ·Px Py Pz·.
·icon· Pattern rotation.
For rectangular parts, this parameter indicates whether a coordinate rotation is to be applied
or not with the measured angle.
·Lx Ly Ø· Part dimensions.
These parameters establish the dimensions of the rectangular or circular part.
For a rectangular part, parameters ·Lx· and ·Ly· indicate the length of the pocket on each
axis. The sign indicates tool orientation.
·Ds· Safety distance.
Optional parameter; if not defined, it assumes the distance between the part and the probe
position when calling the cycle.
Distance with respect to the point to measure, to which the probe approaches before making
the probing movement.
·Dr· Withdrawal distance after initial probing.
This parameter sets the distance the probe withdrawals after the first probing movement.
Once it withdraws this distance, the CNC makes a second probing movement.
·Dz· Safety distance along Z.
Distance for the probe to go up for its movements over the part.
·Fs· Feedrate for the first probing movement.
Optional parameter; if not defined, the cycle assumes the value of machine parameter
PROBEFEED of the axis.
This parameter sets the feedrate for the first probing movement. Then, the CNC will repeat
the probing movement at feedrate ·F·.
Do not preset the part zero.
Preset the part zero at the center of the part.
Preset the part zero at one of the corners (the cycle shows an icon for each
corner).
Do not rotate the coordinates (pattern).
Rotate the coordinates (pattern).
Lx Rectangular part. Part length along the abscissa axis.
Ly Rectangular part. Part length along the ordinate axis.
Ø Circular part. Part diameter.
P1
70
P4P3
P2
P1 Lx=70
P2 Lx=-70
Ly=30
Ly=30
P3
P4 Lx=-70 Ly=-30
Lx=70 Ly=-30
30
To Next Page
Loading...
