Operating manual
CNC 8070
MANUAL (JOG) MODE. PART CENTERING (MILL MODEL)
7.
(REF: 1505)
·129·
Data programming.
·F· Probing feedrate.
Optional parameter; if not defined, the cycle assumes 10% of the value of machine parameter
PROBEFEED of the axis.
This parameter sets the feedrate for the second probing movement.
·icon· Feedrate for approach movements.
This parameter sets the type of feedrate for the movements to the approach points.
Coordinate preset value.
·Px Py Pz· Coordinate preset value on each axis.
These parameters are only valid when presetting the part zero and any this point may be
assigned any value.
The movements are carried out in rapid.
The movements are carried out at work feedrate.
Px Preset value on the abscissa axis.
Py Preset value on the ordinate axis.
Pz Preset value on the axis perpendicular to the plane.
To Next Page
Loading...
