Operating manual
CNC 8070
MANUAL (JOG) MODE. PART CENTERING (MILL MODEL)
7.
(REF: 1505)
·131·
Basic operation.
8 Probing of the third point.
It is done like the previous one.
9 Approach movement to the top surface (only if it has been programmed).
When selecting to measure the surface, the probe moves the ·Dz· distance up in rapid
(G00) and the probe moves to the center of the part.
10 Measuring the top surface (only if it has been programmed).
The probe makes a first probing move, a withdrawal movement and a second probing
move. After the second probing move, the probe withdraws to the approach point.
First probing movement. Probing movement, at feedrate ·Fs·, until touching the part
surface.
Withdrawal movement. Return of the probe in rapid (G00) the distance indicated in ·Dr·.
Second probe. Probing movement at feedrate ·F· until the probe signal is received.
Withdrawal movement. Rapid probe movement (G00) from the probing point to the safety
position.
11 Approach movement to the fourth probing point.
Movement of the probe from the third approach point to the fourth.
12 Probing of the fourth point.
It is done like the previous one.
13 Probe positioning at the calculated center.
This movement is carried out in two stages. It first moves along the perpendicular axis
in rapid (G00) and then in the plane.
To Next Page
Loading...
