·140·
Operating manual
CNC 8070
8.
EDISIMU MODE (EDITING AND SIMULATION)
(REF: 1505)
Program editing and simulation
Block jump
It simulates the external "block skip" switch.
While active, the blocks having the block-skip character "/" will be ignored (not
simulated).
Cancel channel synchronization
There is one icon for each channel. It cancels the channel synchronization
wait periods during simulation.
When active, the wait period will end immediately and it will resume the
execution of the program.
Synchronizing spindles.
There is an icon for each spindle where to indicate the spindle to synchronize
with. The ·0· value cancels the synchronization.
Assume the active origins for execution.
With this option, when starting the simulation or pressing the simulation reset,
the CNC applies to the simulation the origins set in the execution environment
(for example, the part zero set in jog mode).
To Next Page
Loading...
