Fagor CNC 8070 - Profile Editor

·158·
Operating manual
CNC 8070
8.
EDISIMU MODE (EDITING AND SIMULATION)
(REF: 1505)
Working in the editing window.
8.4.9 Profile editor.
The profile editor may be accessed from the softkey menu to edit a new one, or selecting
a profile of the program and pressing the [RECALL] key. The profile editor shows its options
on the softkey menu. See chapter "9 Profile editor".
To return to editing the program, press "End". The softkey menu of the program editor shows
the "insert profile" softkey to insert the defined profile into the program. The block for the
defined profile is inserted after the block where the cursor is.