Fagor CNC 8070 - Canned Cycle Editor

Operating manual
CNC 8070
EDISIMU MODE (EDITING AND SIMULATION)
8.
(REF: 1505)
·159·
Working in the editing window.
8.4.10 Canned cycle editor.
The cycle editor may be accessed from the softkey menu to edit a new one, or selecting a
cycle of the program and pressing the [RECALL] key. The softkey menu of the cycle editor
shows the available canned cycles.
To return to the program editor, press the [BACK] key. The softkey menu of the program editor
shows the "insert cycle" softkey to insert the defined cycle into the program. The block for
the defined cycle is inserted after the block where the cursor is.
Canned cycles have a specific manual both for milling and turning. Refer to the documentation included
in the CD-Rom that comes with the product for further detail.
BACK