·164·
Operating manual
CNC 8070
8.
EDISIMU MODE (EDITING AND SIMULATION)
(REF: 1505)
Program window
8.7 Program window
This window shows the contents of the program selected for simulation and allows selecting
the first and last blocks of the simulation. When not selected, the simulation will begin at the
first block of the block and will end after executing one of the end-of-program functions "M02"
or "M30". While simulating, the window cursor will show the block being simulated.
Description of the program window
The program window shows the following information:
A Title bar.
Name of the program selected for simulation.
B Program blocks selected for simulation.
While simulating, the cursor will indicate the block being simulated. The "active
subroutines" option being active, the window displays information related to the execution
of subroutines, canned cycles, repetition blocks and loops.
C Program line.
Line of the program where the cursor is.
Horizontal softkey menu.
When selecting the program window, the horizontal softkey menu will show the options
related to this window.
Softkey. Description.
Set beginning First block for execution or for manual block search.
Stop condition. Set the condition to end the execution or the manual block search.
Active subroutines. Toggle between the display of program blocks and the display of
information related to the status of the subroutines, canned cycles,
repetition blocks and loops.
Find text. Find text
To Next Page
Loading...
