Fagor CNC 8070 - Profile Editor. Example 2 (Milling)

Operating manual
CNC 8070
PROFILE EDITOR
9.
(REF: 1505)
·185·
Examples of how to define profiles.
9.7.2 Profile editor. Example 2 (milling).
Definition of a profile without rounding.
Section. Geometry.
Starting point X = 100 Y =20
Straight X = 80 Y =20
Straight X = 80 Angle = 90
Counterclockwise arc
(1)
Center X = 75 Radius = 5 Tangency = Yes
Counterclockwise arc
(2)
Center X = 100 Radius = 150 Tangency = Yes
Clockwise arc Center X = 40
Center Y = 80
Radius = 20 Tangency = Yes
• The CNC shows the options for section 2. Select the correct one.
• The CNC shows the options for section 1. Select the correct one.
Clockwise arc (3) Radius = 200 Tangency = Yes
Clockwise arc Center X = 80
Center Y = 160
Radius = 10 Tangency = Yes
• The CNC shows the options for section 3. Select the correct one.
Counterclockwise arc
(4)
Radius = 40 Tangency = Yes
Clockwise arc Center X = 120
Center Y = 160
Radius = 10 Tangency = Yes
• The CNC shows the options for section 4. Select the correct one.
Clockwise arc (5) Radius = 200 Tangency = Yes
Clockwise arc Center X = 160
Center Y = 80
Radius = 20 Tangency = Yes
• The CNC shows the options for section 5. Select the correct one.
Counterclockwise arc
(6)
Center X = 100 Radius = 150 Tangency = Yes
• The CNC shows the options for section 6. Select the correct one.
Counterclockwise arc
(7)
Center X = 125 Radius = 5 Tangency = Yes
• The CNC shows the options for section 7. Select the correct one.
Straight (8) X = 120 Y =20 Tangency = Yes
• The CNC shows the options for section 8. Select the correct one.
Straight X = 100 Y =20