Fagor CNC 8070 - Page 204

·204·
Operating manual
CNC 8070
11.
HD GRAPHIC ENVIRONMENT (MILL MODEL)
(REF: 1505)
Configure the graphics (number of windows, colors, etc.).
Define the sections.
In the configuration window, each section is defined with an origin point and a plane, defined
with its normal vector. The color of each section may also be defined.
• The "Origin" data defines the origin of the section.
• The "Normal" data defines the components of the vector normal to the plane, that defines
the orientation of the plane.
The resulting section will be a plane perpendicular to the vector defined in "Normal" and it
goes through the point defined in "Origin". The default values define three sections, each
of them perpendicular to one of the axes and cut the part in half.
Activate the sections.
Each section may be activated individually. The definition of active windows only affect the
active window (the one having the focus).
To view the sections on the graphic, one must also enable the "view sections" option in the
window properties. If the "view sections" option is not enabled, the graphic does not show
any section even if they are active. If the "view sections" option is not enabled, the graphic
shows the active sections separately.
Color configuration.
This softkey is used to configure the colors for the part and for the tool paths. This
configuration is global for all the windows.
Path colors.
This option is used to assign colors to the following tool paths.
• Rapid traverse (G0).
• Compensated movements.
• Uncompensated movements.
• Canned cycles.
• Tapping.
Y
Z
X
Normal
Zn
0,9
Xn
0
Yn
0,5
Xn
Zn
70
30
Origin
Zo
0
Xo
70
Yo
50
50