·216·
Operating manual
CNC 8070
12.
GRAPHIC ENVIRONMENT (LATHE MODEL)
(REF: 1505)
Real coordinates
12.9 Real coordinates
This softkey is used to draw the real tool path or the theoretical tool path. This option is only
available in line type graphics.
This option is only available when executing the program; not when simulating it. When
selecting this option (the softkey will appear pressed), the CNC draws the actual (real) tool
path.
12.10 Real coordinates with enlarged error
This softkey shows the real path, but enlarging the error with respect to the theoretical path.
The error enlargement factor may be set after pressing the softkey.
This option is only available when executing the program; not when simulating it. When
selecting this option (the softkey will appear pressed), the CNC draws the actual (real) tool
path with enlarged error. Pressing this softkey also activates the one corresponding to the
real path.
12.11 Simulation speed
This softkey is used to change the simulation speed.
This option is only available when simulating the program; not when exeucting it.
Speed "Edit"
It is used to select the new simulation speed. It is selected using the graduated ruler that
indicates the active simulation speed.
When selecting this option, the softkey menu shows the options to set the simulation speed.
To return to the main menu, press the [BACK] key.
Key. Meaning.
To move the ruler cursor.
To Next Page
Loading...
