·224·
Operating manual
CNC 8070
13.
HD GRAPHIC ENVIRONMENT (LATHE MODEL)
(REF: 1505)
Actions (move sections and print graphics).
13.5 Actions (move sections and print graphics).
The softkey menu may be used to carry out the following actions.
Move the active sections.
This option may be used to move the active sections. To move the sections, the active view
must have the "view sections" option enabled and it must also have a section active. To end
the possibility to move sections, press the [ESC] key or press the same softkey again. With
this option active, the bottom of the screen shows a message indicating the active section
and its data.
Select and move the sections.
One of the sections is always selected. To change the section to be moved, use the tab key
or with the [1] [2] [3] keys (depending on the section number). The section to be moved
appears in orange and the rest in the color they have been defined with.
Moving a section is actually changing its origin point which is the point in space defined by
its three coordinates X Y Z. Therefore, moving a non-perpendicular section requires knowing
which coordinate of the origin point is to be moved.
If the section to be moved is perpendicular to one of the axes of the trihedron, like the default
sections, the [][] keys move the section in the positive direction of the axis and the [][]
keys move it in the negative direction of the axis.
If the section is not perpendicular to any of the axes of the trihedron, it is necessary to select
one of the axes of the trihedron (hold one of the keys [X] [Y] [Z] down) and use the [][]
keys move the section in the positive direction of the axis and the [][] keys move it in the
negative direction of the axis.
Print the graphic.
This option may be used to print the graphic out to the predetermined printer or out to a file.
Print the graphic.
This softkey may be used to print the graphics in the pre-determined printer or save it as a
file (bmp format) at the CNC. When printing the graphic to a file, it will be saved in the folder
"C:\Cnc8070\Users\Reports\"; the file name may be selected using the "Print configuration"
softkey.
When selecting this option, the CNC will show a dialog box requesting the print destination
(printer or file). After selecting the destination, press [ENTER] to print it or [ESC] to cancel it.
Print configuration.
This softkey may be used to set the printing properties. When selecting this option, the CNC
shows a dialog box where the following may be defined:
• The title of the graphics that will appear next to it in the print.
• The name of the file where the graphics will be stored when printing out to a file.
After filling out the data, press [ENTER] to accept them or [ESC] to cancel them.
Softkey. Function.
Move the active sections.
Print the graphic out to the predetermined printer or out to
a file.
To Next Page
Loading...
