Operating manual
CNC 8070
USER TABLES
15.
(REF: 1505)
·235·
Fixture table
15.3 Fixture table
This table stores the clamp offsets for each axis. There are up to 10 clamp offsets. The table
highlights in color the active zero offset.
A Machine axes and display units (millimeters, inches or degrees).
B Clamp offset.
C Clamp offset value in each axes of the channel.
The end of this chapter describes how to edit this table.
Fixture offset
The fixture offset besides being set directly in the table may also be set from the PLC or via
part-program using variables.
The clamp offsets are used to set the position of the clamping system of the machine. When
applying a clamp offset, the CNC assumes as new clamp zero the point set by the selected
offset referred to machine reference zero (home). To apply a clamp offset it must be activated
from the program using the relevant variable.
When accessed from the a channel, the table only shows the axes of that channel. The
vertical softkey menu may be used to access the zero offsets of the rest of the channels.
To Next Page
Loading...
