·238·
Operating manual
CNC 8070
15.
USER TABLES
(REF: 1505)
Operations with tables
15.5 Operations with tables
If the arithmetic parameter tables show the parameters of several channels, the softkeys for
initializing, loading, saving and printing the arithmetic parameter tables ask the user to select
the channels.
15.5.1 Data editing
Select the desired table using the horizontal softkey menu. To edit the table data, proceed
as follows:
1 Use the cursor to select the cell whose value is to be changed.
2 Key in the new value.
3 Press [ENTER] to accept the new value or [ESC] to ignore the new value and recover
the previous one.
How to use the calculator to set the data (table of zero offsets and clamp offsets).
Being the focus on any field of the zero offset table or clamp offset table, press [INS] or
[CTRL][K] to access the calculator. The calculator takes the current value of the field and
may be used to perform any operation. Press [INS] to load calculated value into the field and
close the calculator.
Pressing [ENTER] instead of [INS] calculates the value without inserting it into the field and
it allows going on with other operations.
Key. Meaning.
Move the cursor.
Move the cursor page by page.
Move the cursor to the beginning / end of the table.
Accept the value.
Reject the value.
To Next Page
Loading...
