Fagor CNC 8070 - Table for the status of the tool change process

·266·
Operating manual
CNC 8070
16.
TOOL AND MAGAZINE TABLE
(REF: 1505)
Table for the status of the tool change process
16.7 Table for the status of the tool change process
This screen monitors the tool changes being executed in each channel.
It indicates the following for each tool change process:
• The type of change selected and the magazine involved.
The type of change refers to the type of operation being carried out or to be carried out
when executing function M06. The possible types of change are load a tool into the
spindle or load and unload a ground tool from the magazine through the spindle.
• The "execution " LED informs that the tool change process is running and that the
magazine is carrying out an operation.
• The "status" LED informs on whether the magazine is in an error state or not. To eliminate
the error condition, press the reset softkey in the magazine table.