Operating manual
CNC 8070
TOOL AND MAGAZINE TABLE
16.
(REF: 1505)
·267·
Magazine table
16.8 Magazine table
Up to four different magazines may be configured. Each magazine has a table showing the
tool distribution in the magazine and which table is in the spindle and on each holder of the
changer arm (if any). The CNC updates the table data every time a tool is changed.
The table is divided in two panels.
The left panel shows the list of magazine positions. For each position, it indicates whether
it is free, disabled or has a tool. For each tool, it shows the remaining life time (when using
tool life monitoring) and the family it belongs to.
The right panel is informative only; it cannot be selected. This panel shows information about
the magazine status, about the tools in the tool changer arm and about the tool selected on
the list. Optionally, it may show information on the type and configuration of the magazine.
(A)Magazine positions.
(B)Magazine information.
To Next Page
Loading...
