·270·
Operating manual
CNC 8070
16.
TOOL AND MAGAZINE TABLE
(REF: 1505)
Magazine table
16.8.3 Magazine information
The right panel shows different information about the status of the tool magazine and the
tool changer arm. This information is grouped as follows:
Magazine status
This area shows the operation being carried out in the magazine.
In standby: The magazine is in standby.
Loading: A tool is being loaded into the magazine.
Unloading: A tool is being unloaded from the magazine.
Change status
If the magazine is involved in a tool change at a given time, it shows the information about
the status of that change; the operation is carried out when executing an M06, manager
status (in execution or at rest) and the status of the change process (whether it is in error
or not).
Tool information
It shows the data related to the magazine of the tool selected from the list. The "status" led
informs about the tool status.
Green The tool is available.
Yellow The tool life is about to expire.
Red The tool is expired (worn out) or has been rejected by the PLC.
(A)Magazine status.
(B)Tool in the claws of the changer arm.
(C)Tool selected on the list.
(D)Magazine data.
The "Status" led informs the user whether the magazine is in an error state or not.
To eliminate the error condition, press the reset softkey in the magazine table.
To Next Page
Loading...
