·298·
Operating manual
CNC 8070
18.
PLC
(REF: 1505)
Editing in C language or mnemonic language.
18.4.6 Softkey "Customize".
This softkey is used for personalizing (customizing) the behavior, properties and appearance
of the PLC editor.
Customizing the general options of the editor.
Customize the appearance of the editor.
This option customizes the appearance (color, font, etc.) of the elements that make up the
program editor. After defining the new look, press [ENTER] to accept the changes or [ESC]
to ignore them.
Customize the syntax coloring.
This option may be used to customize the color of the elements that make up the program.
After defining the new look, press [ENTER] to accept the changes or [ESC] to ignore them.
In large programs (more than 200 kB), the editor cancels the syntax coloring.
Option. Meaning.
Save always. Activating the automatic saving of the program. When this option is
active, the CNC will automatically save the program every time the
cursor changes blocks. In large programs (more than 200 kB), the
CNC saves the program when the user has not modified the program
for about 5 seconds.
If this option is not active, the program is saved from the softkey
menu. See "18.4.2 Softkey "File"." on page 295.
Line adjust. Adjust the lines to the size of the window.
Show the line number. Show the line numbers at the editor.
Drop menus. Organize the horizontal softkey menu in drop menus.
To Next Page
Loading...
