Operating manual
CNC 8070
PLC
18.
(REF: 1505)
·319·
"Monitoring" service
18.10.2 Definition of the table resources
Each table shows the following resources and user symbols:
Timer table
• Timers (T1...T512).
• User symbols defined for the timers.
Counter table
• Counters (C1...C256).
• User symbols defined for the counters.
Register table
• Registers (R1...R1024).
• User symbols defined for the registers.
• PLC-CNC register variables.
Binary resource table
• Inputs (I1...I1024) and outputs (O1...O1024).
• Marks (M1...M8192).
• Messages (MSG1...MSG1024) and errors (ERR1...ERR1024).
• User symbols defined for the binary resources.
• CNC-PLC boolean variables.
When defining a resource or user symbol, it will be added to the corresponding table.
Data entry
The resources and user symbols of the tables are defined at the data entry area. Their values
may be changed by directly assigning a value to them (M110=1, R300=34). If it is a
hexadecimal value, it must be preceded by the "$" sign (M10=$1, R200=$20).
The window saves the last "N" assignments so they can be recalled later on. In order to make
selecting easier, it is possible to display a window with the list of the assignments already
made.
To remove a resource or user symbol from a table, select that element and press [SUP].
Key. Meaning.
Move the cursor through the list of expressions.
Select an expression from the list.
Show the list of expressions.
Close the list of expressions.
Key. Meaning.
Select a table.
Move the cursor.
Move the cursor page by page.
Move the cursor to the beginning / end of the table.
Delete the selected resource from the table.
To Next Page
Loading...
