Operating manual
CNC 8070
SETUP ASSISTANCE
20.
(REF: 1505)
·349·
Oscilloscope
Zone 1. Focus on a variable of a channel.
When the focus is on any of the variables, the vertical softkeys will be:
Zone 2. Focus on the "T/Div" field.
When the focus is on the "T/Div" field, the following softkeys will appear.
Zone 3. Focus on the "WIN", "C1" and "C2" field.
With "WIN", it shows the oscilloscope window where it is. Cursors "C1" and "C2" may be used
to analyze each signal of the last data capture. These two cursors may be used to obtain
the position in milliseconds of each signal and the time difference between them "".
When the focus is on one of these fields, the following vertical softkeys will be shown.
Zone 4. Focus on the "parameter name" field.
As with variables, by selecting the various parameters, it is possible to change their names
and values.
When pressing [ENTER] after changing the name of a parameter, use the [][]
[][] keys
to move the focus to the next field to change the value of that parameter. After changing the
parameter value and pressing [ENTER], the focus does not go on to the next field. Use the
arrow keys to go on to the next parameter. When the focus is on this field, the 4 vertical
softkeys will be:
The scale of the graphic may be changed with the "scale" softkeys.
The new scale value will appear on the graphic next to the
corresponding variable.
The graphics of the desired channel may be moved up and down
using the offset softkeys.
This softkey may also be used to center the graphics.
When the focus is on any of the variables, a new variable name may be either keyed in or selected
without having to go to "CONFIG".
Using the autoscale softkey, the oscilloscope selects the right time
scale so the signal appears as large as possible inside its
corresponding graphic area.
It increases or decreases the time scale.
It takes the window to the beginning or to the end.
It takes the window to the trigger. If there is no trigger, it will go to
the center of the window.
Moves the window to the left or to the right.
It increases the value of the parameter in the amount indicated on the
configuration screen.
To Next Page
Loading...
