Operating manual
CNC 8070
SETUP ASSISTANCE
20.
(REF: 1505)
·357·
The Bode diagram
20.2.1 Interface description
The screen of the Bode diagram is similar to that of the oscilloscope and looks like this, with
two clearly different parts. The left side and the lower side show the selected axis, the various
ways to display the captured data, the time base or frequency base and the parameters that
may be acted upon. The top right side shows the data graphically.
A Ways to represent the captured data in the graphic window. Up to 4 graphs may be
displayed at the same time. The user can change the type of graph without having to do
a new capture.
B Graphic window where the selected data is represented. For each graph, it shows the
scale used to draw it.
C Time base.
D Machine parameters to be set. With the oscilloscope, it is possible to change the value
of up to 22 machine parameters to check their effect during the adjusting process.
Some of this data may also be defined at the configuration screen. See "20.2.4 Configuration
screen" on page 363.
To Next Page
Loading...
