Operating manual
CNC 8070
SETUP ASSISTANCE
20.
(REF: 1505)
·363·
The Bode diagram
20.2.4 Configuration screen
The configuration screen may be accessed with the "Config" softkey. This screen shows four
different areas.
• The selected axis and the two variables to be displayed.
• The selected types of graph.
• The capture configuration data.
• The data of the movement and of the excitation signal.
Axis
Axis whose Bode is to be obtained.
Type of capture
The variables that are captured (In/Out) are preset in all types of capture except in the
"ADVANCED" type where they are set by the user.
Variable. Meaning.
ADVANCED "In/Out" variables that may be set by the user.
CUR_CL Closed current loop.
Current command / current feedback.
VEL_CL Closed velocity loop.
Velocity command / velocity feedback.
POS_CL Closed position loop.
Position command / position feedback.
CUR_OL Open current loop.
VEL_OL Open velocity loop.
POS_OL Open position loop.
TF_CURCOM_MOTSPE Transfer function.
Current command / motor speed.
TF_MOTSPE_LOASPE Transfer function.
Motor speed / load speed.
To Next Page
Loading...
