Operating manual
CNC 8070
SETUP ASSISTANCE
20.
(REF: 1505)
·377·
The circularity (roundness) test
20.3.9 Machine parameters that may be modified
General machine parameters.
Axis machine parameter.
Parameter Units Update
PRELFITI ms Immediate
PRELOAD % Immediate
TCOMPLIM % Immediate
TINTIME ms Immediate
TPROGAIN % Immediate
Parameter Units Update
BACKLASH mm(inch) or degrees Immediate
BAKANOUT rpm Immediate
BAKTIME ms Immediate
ACCEL mm(inch)/s² or degrees/s² Beginning of the next block
ACCJERK mm(inch)/s³ or degrees/s³ Beginning of the next block
ACFGAIN % Immediate
ACFWFACTOR ms Immediate
DECEL mm(inch)/s² or degrees/s² Beginning of the next block
DECJERK mm(inch)/s³ or degrees/s³ Beginning of the next block
FFGAIN % Immediate
G00FEED mm(inch) or degrees Beginning of the next block
INPOSW mm(inch) or degrees Immediate
LACC1 mm(inch)/s² or degrees/s² Beginning of the next block
LACC2 mm(inch)/s² or degrees/s² Beginning of the next block
LFEED mm(inch) or degrees Beginning of the next block
MANACFGAIN % Immediate
MANFFGAIN % Immediate
MAXVOLT mV Immediate
PROGAIN 1000/min Immediate
SERVOOFF Immediate
To Next Page
Loading...
