Operating manual
CNC 8070
DDSSETUP
21.
(REF: 1505)
·383·
Drives accessing level (only Sercos).
21.3 Drives accessing level (only Sercos).
The parameters, variables and commands of the drive are organized by access levels. To
access each parameter, the drive must be configured at the access level required by that
parameter. A password is needed to access each level.
The available access levels are the following:
• Basic level (USER)
It is the default level, it is accessed when entering the DDSSetup mode. It requires no
password. The user level gives access to a group of parameters that slightly changes
the operation of the drive.
• Intermediate level (OEM)
This level gives access to a large group of parameters that depend on the motor
connected, they set how the electronics of the drive is adapted to that motor.
• Maximum level (FAGOR)
This level gives full access to all the variables, parameters and commands of the system.
This softkey is used to change the access level for drive parameters and variables. Pressing
this softkey shows a window that requests the password to quit the basic level and access
a new level.
The Fagor level gives access to a group of parameters depending on the drive's electronics and they
factory set. Only technicians from Fagor Automation are granted a FAGOR access level.
To Next Page
Loading...
