·386·
Operating manual
CNC 8070
21.
DDSSETUP
(REF: 1505)
–Error management– service.
21.5 –Error management– service.
The top of the window shows the list of the available devices. The command line is located
at the bottom of the window. See "21.9 Command line." on page 392.
Disable the errors (only Sercos).
To disable an error of the drive, use the "Error listing" softkey of the horizontal menu. This
softkey shows the whole list of possible errors. To disable the desired ones, checkmark the
box on the left.
Then, press the "Send" softkey to send the list to the drive. To make the error disabling
effective, execute the command DC1 (reset errors) from the command bar.
Disabling the errors requires an OEM or FAGOR access level. See "21.3 Drives accessing
level (only Sercos)." on page 383. Even then, only resettable errors may be disabled, even
if the list also shows the non-resettable errors.
Refer to the alarms log of the device (only Mechatrolink).
The horizontal softkey menu shows the list of warnings, alarms and errors active at the device
and, if the device allows it, the alarms log of the device.
The information shown by this service depends on the type of bus used, Sercos or
Mechatrolink.
Sercos. This service shows the list of errors detected by the drive and lets disable
them. The errors are shown in the order they come up. Once the cause
of the error has been corrected, the errors may be reset with the "Error
reset" softkey of the horizontal menu.
Mechatrolink. This service shows the list of warnings, alarms and errors active at the
device and, if the device allows it, the alarms log.
Softkey. Function.
List of active warnings, alarms and errors.
This softkey shows the list of warnings, alarms and errors active at the device.
Alarms log of the device.
This softkey shows the alarms log of the device, if it offers this option.
To Next Page
Loading...
