·388·
Operating manual
CNC 8070
21.
DDSSETUP
(REF: 1505)
–Monitoring– service
DDSSetup. The monitoring window always shows the variables with the node number (drive
ID) of the device and its abbreviation (MLINK3.5 (APOS)).
Monitoring the status of variables or parameters
Use the softkeys of the horizontal menu to start and stop the monitoring of variables. While
monitoring, the window shows the following symbols next to each variable to indicate its
status.
Channel occupied.
Channel occupied by DRV variables or timeout.
Reading error.
To Next Page
Loading...
