CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 108 of 128
Errors 7000-7999
7030 M6 without T'
DETECTION During execution.
CAUSE An M6 has been detected without its corresponding T. If parameter "M6 ALONE =
NO", an error is issued.
SOLUTION M6 cannot be programmed without the corresponding T.
7031 'T with two M6'
DETECTION During execution.
CAUSE Two consecutive M6 have been detected for the same T.
SOLUTION Check the program.
7032 'Error in the PLC operation'
DETECTION During execution.
CAUSE Wrong sequence in the PLC program.
SOLUTION Check the PLC program.
7033 'The PLC generated an emergency in the tool magazine'
DETECTION When the PLC is running.
CAUSE The PLC sets the emergency mark to the tool manager.
SOLUTION Remove the emergency.
7034 'Operation error: No room could be found in the magazine'
DETECTION During execution.
CAUSE The PLC maneuver generates an error.
SOLUTION Check the PLC program.
7035 'Error in the magazine table'
DETECTION During execution.
CAUSE Error at the magazine during a maneuver.
SOLUTION Check the magazine status. Maybe there is no room in the magazine.
7036 'It is not possible to change the family of tools that are in the magazine or in the
spindle'
DETECTION While editing tables or during execution.
CAUSE For safety reasons, it is not possible to change the family of a tool that is in the
magazine.
SOLUTION First unload the tool.
7037 'The spindle must be empty for the LOAD and UNLOAD modes'
DETECTION During execution.
CAUSE To change the magazine mode to load or unload mode, the spindle (and the arms
in the magazines where the case might be).
SOLUTION Empty the spindle and the arms.
7039 'A tool cannot be in the spindle and in the arm 2 at the same time'
DETECTION During execution.
CAUSE This special case can only occur when using asynchronous or synchronous
magazines with a tool changer and requesting the same tool that is in arm 2
SOLUTION This situation is atypical and it can probably occur only after an error. To correct it,
program a T0 M6 to return the tool to the magazine and be able to resume normally.
7040 'Operation error: First empty arm 1'
DETECTION During execution.
CAUSE This special case can only occur when using asynchronous or synchronous
magazines with a tool changer and requesting the same tool that is in arm 1
SOLUTION This situation is atypical and it can probably occur only after an error. To correct it,
program a T0 M6 to return the tool to the magazine and be able to resume normally.
To Next Page
Loading...
