Fagor CNC8 070 - 8239 Y Programmed Twice; 8240 Z Programmed Twice; 8241 Parameter out of Range; 8242 Bracket Missing

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 114 of 128
Errors 8000-8999
8239 '"Y" programmed twice'
DETECTION During editing.
CAUSE The Y axis has been programmed more than once in the block.
SOLUTION Program the Y axis only once in the block.
8240 '"Z" programmed twice'
DETECTION During editing.
CAUSE The Z axis has been programmed more than once in the block.
SOLUTION Program the Z axis only once in the block.
8241 'Parameter out of range'
DETECTION During execution.
CAUSE The programmed value for the parameter of the instruction is too high.
SOLUTION Program a smaller value for the parameter of the instruction.
8242 'Bracket missing'
DETECTION During editing and execution in MDI.
CAUSE The possible causes are:
• The parameters of the programmed instruction must be between brackets.
• The variable requires programming an index between brackets.
SOLUTION Check the syntax of the instruction or variable in the programming manual.
8243 '"I" programmed twice'
DETECTION During editing.
CAUSE The I axis has been programmed more than once in the block.
SOLUTION Program the "I" value only once in the block.
8244 '"J" programmed twice'
DETECTION During editing.
CAUSE The J axis has been programmed more than once in the block.
SOLUTION Program the "J" value only once in the block.
8245 '"K" programmed twice'
DETECTION During editing.
CAUSE The K axis has been programmed more than once in the block.
SOLUTION Program the "K" value only once in the block.
8247 'Only R1 can be part of an expression'
DETECTION During editing.
CAUSE The radius value has not been programmed correctly.
SOLUTION The radius can only be programmed with "R" or "R1".
8250 'Axis variable without writing permission'
DETECTION During editing.
CAUSE An attempt has been made to write an axis variable that does not have a writing
permission.
SOLUTION The variable can only be read.
8251 'Global variable without writing permission'
DETECTION During editing.
CAUSE An attempt has been made to write a global variable that does not have a writing
permission.
SOLUTION The variable can only be read.
8253 'Axes missing in G20'
DETECTION During editing.
CAUSE Not all the parameters required by function G20 have been programmed.
SOLUTION Check the G20 programming syntax.