CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 116 of 128
Errors 8000-8999
8279 'Mirror image repeated'
DETECTION During editing.
CAUSE The possible causes are:
1. Function G11, G12 or G13 has been programmed more than one in the same
block.
2. Functions G10 and G11, G12 or G13 have been programmed in the same block.
3. Functions G14 and G11, G12 or G13 have been programmed in the same block.
SOLUTION The solutions are:
1. Functions G11, G12 and G13 may be combined in the same block, but each of
them can only be programmed once.
2. Function G10 cannot be programmed in the same block as G11, G12 or G13.
3. Function G14 cannot be programmed in the same block as G11, G12 or G13.
8280 'Negative spindle positioning (orienting) speed'
DETECTION During editing.
CAUSE A negative spindle speed has been programmed in M19 (Sx.POS).
SOLUTION The positioning (orienting) speed must be positive.
8281 'Spindle positioning (orienting) speed programmed twice'
DETECTION During editing and execution in MDI.
CAUSE The spindle positioning speed in M19 has been programmed more than once in the
same block.
SOLUTION Program the spindle positioning speed "S.POS" only once.
8282 'Cycle parameter repeated'
DETECTION During editing.
CAUSE The canned cycle parameter has been programmed more than once in the block.
SOLUTION Each canned cycle parameter can only be programmed once in the block.
8283 'Wrong parameter in canned cycle'
DETECTION During editing.
CAUSE The parameter programmed for this canned cycle is wrong.
SOLUTION Check the programming manual for the parameters required and allowed by each
canned cycle.
8284 'PLC variable without writing permission'
DETECTION During editing.
CAUSE An attempt has been made to write a PLC variable that does not have a writing
permission.
SOLUTION The variable can only be read.
8285 'G20: negative sign only allowed on the longitudinal axis'
DETECTION During editing.
CAUSE An axis that is not longitudinal has been programmed with a negative sign in function
G20.
SOLUTION In G20, only the longitudinal axis can have a negative sign. The longitudinal axis is
the one that contains the tool and is indicated in parameter 3 or 5.
8290 'Variable of the tool manager without writing permission'
DETECTION During editing.
CAUSE An attempt has been made to write a variable of the tool manager that does not have
a writing permission.
SOLUTION The variable can only be read.
8291 'Variable of the machine parameters without writing permission'
DETECTION During editing.
CAUSE An attempt has been made to write a variable of machine parameters that does not
have a writing permission.
SOLUTION The variable can only be read.
To Next Page
Loading...
