Fagor CNC8 070 - 8297 Parameter Repeated; 8299 Brackets Missing Around the List of Parameters; 8300 G170, G171 and G157 Require at Least One Axis; 8302 The Minimum X Coordinate Must be Smaller than the Maximum

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 117 of 128
Errors 8000-8999
8297 'Parameter repeated'
DETECTION During editing.
CAUSE The possible causes are:
1. The parameter CONTERROR has been programmed more than once in the
#HSC instruction.
2. In the subroutine calling instruction #PCALL, #MCALL or G function with
associated subroutine, some parameter has been written more than once.
3. Some parameter has been programmed more than once in the #PROBE or
#POLY instruction.
SOLUTION Program each parameter only once in the block.
8299 'Brackets missing around the list of parameters'
DETECTION During editing and execution in MDI.
CAUSE The programmed instruction requires that its list of parameters be between
parenthesis.
SOLUTION Check the syntax of the instruction in the programming manual.
8300 'G170, G171 and G157 require at least one axis'
DETECTION During editing.
CAUSE No axis has been programmed with function G170, G171 or G157.
SOLUTION Program the axis or axes to be affected by function G170, G171 or G157.
8302 'The minimum X coordinate must be smaller than the maximum'
DETECTION During editing.
CAUSE In the #DGWZ instruction, the programmed minimum X coordinate is equal to or
greater than the maximum.
SOLUTION The minimum coordinate must be smaller than the maximum.
8303 'The minimum Y coordinate must be smaller than the maximum'
DETECTION During editing.
CAUSE In the #DGWZ instruction, the programmed minimum Y coordinate is equal to or
greater than the maximum.
SOLUTION The minimum coordinate must be smaller than the maximum.
8304 'The minimum Z coordinate must be smaller than the maximum'
DETECTION During editing.
CAUSE In the #DGWZ instruction, the programmed minimum Z coordinate is equal to or
greater than the maximum.
SOLUTION The minimum coordinate must be smaller than the maximum.
8306 'G201 requires programming the special function #AXIS'
DETECTION During editing.
CAUSE The #AXIS instruction has not been programmed in the same block as function G201.
SOLUTION Function G201 requires programming the #AXIS instruction in the same block. This
instruction must indicate the axes affected by the G function.
8307 'The third primary axis has been programmed wrong'
DETECTION During editing.
CAUSE In the G20 instruction, parameter 5 has been programmed the same as parameter
1 or parameter 2.
SOLUTION Parameter 5 must be different from parameter 1 and parameter 2.
8308 'Expression or K expected after G04'
DETECTION During editing.
CAUSE Function G4 has been programmed wrong.
SOLUTION Function G4 can be programmed as:
1. G4 <Dwell time>
2. G4 <Dwell time>