CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 56 of 128
Errors 1000-1999
1510 'The axis does not exist or is not available in the channel'
DETECTION During execution.
CAUSE The possible causes are:
• An attempt has been made to move an axis that does not exist or is not available
in the channel.
• An attempt has been made to execute an instruction that involves an axis that
does not exist or is not available in the channel.
• An attempt has been made to read or write an axis variable for an axis that does
not exist or is not available in the channel.
SOLUTION Indicate, in any of the previous actions, axes that belong to the channel.
An new axis may be included in the channel by modifying the machine parameters
of the channel CHNAXIS and CHAXISNAME or using the instructions #SET AX or
#CALL AX.
1511 'The tool is not in the magazine'
DETECTION During execution.
CAUSE An attempt has been made to use the TM.P[ ] variable to read the magazine position
of a tool that is not there.
SOLUTION It is only possible to read the position of the tools that are in the magazine.
1512 'Free or nonexistent magazine position'
DETECTION During execution.
CAUSE An attempt has been made to use the TM.T[ ] variable to read the number of a tool
located in a nonexistent magazine position.
SOLUTION It is only possible to read the tool that is a in valid magazine position.
1513 'Error when writing the variable'
DETECTION During execution.
CAUSE An attempt has been made to write a variable and:
• The variable does not exist.
• It is an axis variable, but the axis does not exist.
• It is an axis variable, but it does not exist for the type of axis.
• It is an axis variable, but it does not exist for the type of drive of the axis.
• The combined operator (+=, ...) is not allowed for that variable.
• The value to write is not valid for that variable.
SOLUTION Check the syntax of the variable and the value to write in it.
1514 'A 2D-3D pocket cannot be executed while G72 is active'
DETECTION During execution.
CAUSE A scaling factor (G72 or #SCALE[n] command) is already active when trying to
execute a pocket.
SOLUTION Cancel the scaling factor.
1515 'One or several axes of the original configuration are not available'
DETECTION During execution.
CAUSE An axis of the temporary exchange has been released and cannot be restored with
a reset or beginning of a program because the channel that took it has not released
(freed) it.
SOLUTION The other channel will release the axis with reset or with the beginning of another
program. The axis release can also be programmed with the instruction #FREE AX.
1516 'Value expected'
DETECTION During execution.
CAUSE The list of subroutine calling parameters (with #PCALL or G180-189) has been
programmed wrong.
SOLUTION The list of parameters to call a subroutine may consist of:
• Local arithmetic parameters: P0 = 30.
• letters: A = 30 or A30.
Both can be mixed on the list.
To Next Page
Loading...
