Fagor CO-502 W - Page 30

30
FAULT
POSSIBLE CAUSE
SOLUTION
Unsatisfactory wash.
Wash distributors
obstructed.
Clean distributors thoroughly.
Shortage of detergent.
Call the technical service to reset the dispenser.
Dirty filters.
Clean the filters thoroughly.
Presence of foam.
Unsuitable detergent. Call the technical service
to supply correct detergent.
Too much rinse aid. Call the technical service to
reset the dispenser.
Temperature of lower tub at
50 ⁰C / 122 ⁰F.
Thermostat faulty or incorrectly set. Call the
technical service to repair it.
Length of cycle too short for
level of dirt on dishes.
Select a longer cycle.
Water too dirty.
Drain the wash tub and fill with clean water.
Dishes and
kitchenware are not
dry.
There is no rinse aid
Fill the rinse aid container.
Rinse aid low.
Call technical service to adjust dispenser.
Dishes left inside
dishwasher for too long.
When the dishwasher finishes, remove the
basket from the machine and allow to dry
naturally.
Rinse temperature lower
than 80 ⁰C / 176 ⁰F.
Call technical service to analyse problem.
Scratches or stains on
dishes.
Too much rinse aid.
Call technical service to adjust rinse aid
dispenser.
Water too chalky.
Check water hardness.
Machine stops during
operation.
Electrical installation
overloaded.
Call technical service to modify electrical
installation.
Machine protection has
tripped.
Reset safety device and if it trips again, call
technical service.
Machine stops and
fills with water when it
is washing.
Pressure switch pipe
blocked.
Empty the tub and clean thoroughly.
Pressure switch faulty.
Call the technical service to replace it.
Overflow incorrectly
mounted.
Mount overflow correctly.
The machine does not
start with the wash
cycle.
Hood/door is not closed
properly.
Close the hood/door correctly and if it is seen to
re-open alone, call the technical services to
adjust the tensioners.
Hood/door micro switch
faulty.
Call the technical service to replace it.
Machine does not
drain completely.
Machine not levelled
correctly.
Level the machine. In the event of doubt, please
contact your technical service.
Pressure switch faulty.
Call the technical service to replace the
pressure switch.
NOTE: If a fault occurs and is not listed in the above table, please call the
technical service. The manufacturer reserves the right to modify the
technical characteristics with prior warning.