EN
38
5.1.9.2 Drainage using the drainage pump (optional)
The drainage using the drainage pump option is only available on request in the A models. The
drainage pipe must always be fitted on a siphon to prevent the return of odours.To drain the machine
using this method, proceed as follows:
• Remove the overflow valve.
• Select the drainage function on the selector switch (H).
• Press START (B) button, the START button light (B) comes on, the drainage cycle will start
automatically.
• At the end of the cycle (approx. 160 s), the START button light (B) goes off, replace the
overflow valve. The machine may be switched off.
In the B models, except SOFT models, proceed as follows:
• Remove the overflow valve.
• Open the door and press the button P1 for 3 seconds and the drainage cycle will start
automatically.
• At the end of the cycle, the machine may be switched off.
To drain the machine with the drainage pump, the hose must be at a
height (max. 680 mm).
5.1.10 Regeneration cycle (only SOFT models)
In the A models, the dishwasher is fitted with a manual regeneration or descaling system for water
with a hardness equal to or greater than 10
°
f. This means that the water entering the machine must
be softened. If this system is not fitted, the machine pipes may become blocked due to the build-up
of too much limescale. To ensure that the system operates correctly, proceed as follows:
• Make sure that the deposit contains rock salt. SEE PILOT LIGHT.
• The regeneration cycle should be run at the end of each working day.
• The process takes 20 minutes, during which the machine cannot be used for washing.
To run the regeneration cycle, proceed as follows:
• Select regeneration cycle (I).
• Press the START (B) button, the START button light (B) comes on.
• After 20 minutes, the START button light (B) goes off, the machine may be switched off.
In the B models, to do this, carry out the following operations:
• Open the door.
• Remove the overflow and wait for the tank to drain.
• When the tank has drained and with the door open, select the regeneration cycle by
pressing P1 for 3 seconds until the pilot light stays on.
• Close the door and the regeneration cycle starts, the pilot light stays on and flashing until the
end of the cycle.
• After approximately 20 minutes, the pilot light goes out indicating that the regeneration cycle
has finished.
• When the regeneration cycle has finished, open the door and mount the overflow in place.
• Close the door and the machine will start to fill the tank as it is empty.
• Fill the tank with salt every week, closing the cap correctly.
The appearance of streaks of lime on the clean dishes is an indication of the need to
urgently run the descaling or regeneration cycle.
5.1.11 Switching off the machine
In the A models, to switch off the machine, turn the selector to 0.
In the B models, the dishwasher is switched off by pressing the ON/OFF button for 1.5 seconds.
The machine should not be switched off during the wash process as this will stop the tableware
inside the machine from being cleaned properly.
5.1.12 Cleaning the machine at the end of the day
At the end of the day, the filters, wash distributors, rinse branches and other accessories must be
cleaned. This is necessary to prolong the service life of the machine. To ensure the efficient washing
of the dishes, the dishwasher must be perfectly clean and disinfected.
To Next Page
Loading...
