13
6 OPERATIONS
6.1 WASHING
Fig. 7 Control Panel
• Set selector switch (1) to desired time setting. (FI-48W, 120 or 180 Second / FI-64W & FI-
72W, 90 or 180 Second) This will turn your machine ON. Indicator light (2) will illuminate.
Machine will automatically begin to fill and heat the water in the boiler and tank to the proper
temperatures.
• Wait for the rinse gauge (3) to read ≥ 180º F (83˚C) and your wash tank gauge (4) to read ≥
150º F (66˚C). (Time will vary depending on incoming water temperature)
Note: To speed up the warm up process, you can run the Dishwasher a couple of times
only after the Rinse Gauge (3) is ≥ 180º F (83˚C).
• Open the door, load your dishwasher and close the door.
• Start the wash by pressing and holding your start button (5) until your machine begins to wash.
Start switch (5) will illuminate during operation.
• Wash is completed when the start button (5) turns off.
• Open the door and repeat process.
If you start your dishwasher prior to your booster heater
(3) reaching a minimum of 180º F (83
ºC),
YOU WILL HAVE AN EXTENDED
WASH CYCLE!
To Next Page
Loading...
