10
6.3 DRAINING AND CLEANING
Draining must occur EVERY DAY and if in a high application;
It should be drained after each meal rush!
Fig.8 Control Panel
• Switch selector switch (1) to the 0 setting. (OFF) (Fig. 8)
• Remove the overflow tube by inserting a finger into the top of the tube. (Fig.10)
DO NOT REMOVE SCRAP BASKET! DO NOT LOOSE O’RING!
• Close the door.
• Set selector switch (1) to for drain.
• Depress the start button (4) to start the drain pump. Start Button (4) will illuminate.
• Wait until the Start Button (4) turns off. (3 minutes)
• Open door.
• Take out scrap basket for cleaning by twisting to the left. (Fig. 11)
• Replace scrap basket, lock into position by twisting to the right and replace overflow tube with
O-ring.
• Switch selector switch (1) back to the OFF position.
• Wipe clean and dry the machine if the day is completed. Leave door open until the next day’s
operations or to the time settings to begin using the machine again.
To Next Page
Loading...
