8. Push the oven towards the inside and fasten it to the unit with the 2 screws
(Figure 2) that you will find in the bag of accessories that came with the oven.
9. Push the control knob supplements into place depending on the correspon-
ding type of heat. All the supplements are in the bag of accessories that
came with the oven or the cooking hob. Next put the control knobs in place.
You will find these in the bag of accessories that came with the oven.
10. If the cooking function selector is not at position “0”, turn it to “0” and set the
time on the oven.
13
5. Insert the oven into the gap in the furniture
unit leaving the switch box on top of the oven.
7. Insert the switch box over the centring bolts of
the component carrier as far as it will go and
fasten the 2 screws on the top.
4. Next you must install the hob over the gap in the worktop, bearing in mind
that the switch box is hanging from the hob. Respect the hob installation
requirements (refer to the hob instruction manual).
6. Insert the cable into the oven connector.
3. Release the switch box
that goes under the
cooking hob.
2. Place the cooking hob
on top of the worktop.
To Next Page
Loading...
