Fagor PBZ4VQ247FN - Page 36

36
OPERATION
Switch on the appliance
When the appliance is switched o then all the cooking zones are disconnected and the in-
dicators are o.
Touch On/O (1) to turn on the appliance and activate the desired cooking zone. “0” will be
shown on for 10 seconds on the cooking zone display (3). Now the desired heat setting can
be set using the (+)(4) or (-)(3) sensor elds (see "Set the heating power").
If none of the sensors is touched within 10 seconds, the appliance switches
itselfo.
Ifchildlock functionisactivated,the appliance cannotbe switchedon (see
"Releasethechildlock").
Switchonthecookingzone
Control Panel
When you connect the appliance to power, Child Lock indicator (5) will be on. Touch and hold
the Child Lock sensor (5) until the indicator is o. Now you can use the appliance.
No objects should be placed on the sensors (this could cause an error). Touch
sensorsshouldbealwayskeptclean.
Touch Of/O (1) to turn on the appliance and activate the desired cooking zone. Then operate
the cooking zone as follows:
1. Select the desired cooking zone using the cooking zone selection sensor eld (1) (sensor
eld layout reects the layout of individual cooking zones),
2. Set the desired heat setting using the (+)(4) or (-)(3) sensor elds,
3. To change the heat setting again as described in point 1, select the desired cooking zone
using the cooking zone selection sensor eld (1), and then set the desired heat setting
using the (+)(4) or (-)(3) sensor elds.
If noneofthe sensor eldsistouched within 10seconds, the cooking zone
switcheso.
Acookingzoneisactivewhenitsdisplayisbrighterthantheothers.Thisindi-
catesacookingzoneisreadyfortheheatsettingtobesetorchanged.