Fagor QC-PDS - Page 103

 Drives
DRIVES
Single-drives
3.
Ref.2003
· 103 ·
QC-PDS
HARDWARE
A19/X11 connector.
Motor power connection
Male 3-pin connector located on top of the drive and identified as A19/X11.
QC-DR-080-F  | QC-DR-120-F 
Female aerial plug connector with screw connection with tension sleeve
supplied as an accessory. They are used to connect the power to the
motor. Accordingly, this connector will be available for the indicated models
to power the motor.
The following table shows the main data of the aerial plug-in connector and
the wire to be connected:
Pinout
The pinout is printed on the connector as U1/U-V1/V-W1/W.
Installation
See section, 8.5.3 MOTOR POWER CONNECTION.
Connector data
Nr of poles 3
Gap (mm)
15
Tightening torque (N·m) for S
 25 mm² / S >25 mm²
2.5/4.5
Flat screwdriver, size (mm) 1.0 x 4.0
Minimum section (mm²)
See table T. H3/6
Maximum section permitted (mm²)
35
Maximum nominal input current (A) 92.3
Connection data
Length to strip (mm)
20