Fagor QC-PDS - Page 104

 Drives
138
3.
DRIVES
Single-drives
· 104 ·
Ref.2003
· 104 ·
QC-PDS
HARDWARE
U1/U, V1/V, W1/W bolts.
Motor power connection
M10 threaded bolts located at the top of the drive and identified as U1/U,
V1/V, W1/W at the top of the plate to supply electrical power to the U, V, W
power phases of the motor, respectively.
QC-DR-275- 
FAGOR provides M10 nuts and washers as accessories, but not the
terminals that must be pre-crimped at the end of each MPC-1xS single-pole
cable before making the connection for each phase. See the figure.
Pinout
The pinout is printed as U1/U-V1/V-W1/W on the upper part of the of the
front plate of the unit.
Installation
See section, BRAKELESS FEED AXIS SERVOMOTOR on 8.5.3 MOTOR POWER
CONNECTION.
F. H3/36
U1/U-V1/V-W1/W bolts. Connection for the single-pole power cables (1 per
phase) from the spindle motor to the drive.
F. H3/37
U1/U-V1/V-W1/W bolts. Pinout.
Note. FAGOR does not supply the terminals
Single-pole cables
3x 1x150
per phase
Bolts
U1/U
V1/V
W1/W
M10
3x
M10 washers.
M10 nut
DIN 6923
U1/U, V1/V, W1/W