Installation
8.
INSTALLATION
Electrical connections
302
Ref.2003
· 284 ·
QC-PDS
HARDWARE
QC-APS3-15 + QC-RPS-
-F
The connection is made using two 2.5 mm² conductors to connect,
respectively, the under cover +24V/GND terminals of the A18 connector of
the QC-APS3-15 auxiliary power supply with the under cover +24V/GND
terminals of the A18 connector of the adjacent QC-RPS-
-F
power
supply. See figure.
All the information regarding the A18 connector is available in the chapter
regarding the applicable module, power supply, drive or auxiliary module.
F. H8/35
Connector A18. +24 V DC output of the QC-APS3-15 auxiliary power supply.
A18
QC-APS3-15
QC-RPS-030-FF2 QC-DR-40-FS2
QC-DR-30+30-FD2
QC-BPM-100
To Next Page
Loading...