88
3.6. Injector replacement.
If the appliance is installed in a country where it is necessary to change the injector diameter or
even to install the appliance ready for operation with another type of approved gas, please call the
technical service to make the change.
Please follow the instructions below to change the gas supply from propane to natural gas.
PROCEDURE:
All the dryers are fitted with a 1/2” gas inlet. Never connect a pipe with an inner diameter less than
this.
VALVE HANGING BAG
1- Locate the Injector on the left side of the valve covered by a metal plate. Unscrew and
remove the injector using the socket wrench.
Natural gas injector (found in the BAG close
to the valve).
To Next Page
Loading...